How to work it out
Spouting lengths
Add up each run and buy lengths with the fewest joins. Long runs need an expansion joiner or an expansion outlet.
Brackets
Marley brackets go no more than 500 mm apart (300 mm in high-wind or snow areas), plus one at each end and extra each side of expansion joiners. Each bracket takes at least three stainless screws.
Corners and ends
Count internal and external corners, and a stop end wherever a run finishes without turning a corner.
Downpipes
One outlet per downpipe, plus bends for the offset and clips up the wall.
Worked example
A house with 40 m of spouting on four sides (12, 8, 12 and 8 m), four external corners, two RP80 downpipes and Marley Stormcloud® in white.
| Item | Qty |
|---|---|
| Spouting | |
| Marley Stormcloud® spoutingWhite · 5 m · MS1.5 | 8 lengths |
| Spouting bracketsWhite · MS2 · Every 500 mm + each end | 85 brackets |
| Spouting joinersWhite · MS5 · Where lengths join | 5 joiners |
| Expansion joinersWhite · MS17 · Runs over 16 m or without an expansion outlet · brackets 400 mm each side | 1 joiners |
| External corners 90°White · MS6 | 4 corners |
| Expansion outletsWhite · 80 mm · MS8-80 · One per downpipe | 2 outlets |
| Downpipe | |
| RP80® downpipeWhite · 3 m lengths · 2 downpipes × ≈2.9 m | 2 lengths |
| RP80® bendsWhite · M+F · 2 per offset + 1 at the bottom | 6 bends |
| RP80® downpipe clipsWhite · First within 200 mm of the bend, then max 1.2 m apart | 6 clips |
| Fixings | |
| Stainless screws6g × 20 mm stainless · pack of 100 · ≈267 screws · 3 per bracket, 2 per downpipe clip (per Marley) | 3 packs |
| Marley MCS® solvent cementWhite · ≈31 joints · don’t glue into expansion outlets or joiners | 1 tins |
This is the list Takeoff produced for that job. Your list will change with your sizes and settings.
Check before you buy
- Codes are Marley part numbers (MS = Stormcloud®); colour suffixes vary — confirm against your Marley list. Fall: at least 5 mm per 10 m towards outlets.
What the calculator covers
- All Marley spouting profiles
- 1.5, 3 and 5 m lengths
- RP80 and RP65 downpipes
- Internal and external corners and stop ends
- Expansion joiners and outlets
- Downpipe bends and clips
- Screws and solvent cement
Questions
How many spouting brackets do I need?
Allow one every 500 mm plus one at each end. The 40 m example on this page needs 85 brackets.
How much fall does spouting need?
Marley asks for at least 5 mm of fall for every 10 m of run towards the outlets. More fall drains and self-cleans better.
How many downpipes do I need?
It depends on the roof area and rainfall for your site. Takeoff lists what you enter — check the Marley guide or your plans for the number.
Get your own list in under a minute
Put in your sizes. Print it, save it as a PDF, email it or take it to your supplier.
Start your spouting list