How to work it out
Ceiling
Ceiling area is the floor area of each room. Divide by the coverage on the pack and round up.
Walls
Use the length of outside walls × the stud height, less doors and windows. Internal walls usually only get acoustic batts.
Underfloor
Underfloor uses the floor area again. On a timber floor on piles, a polythene ground moisture barrier goes down too.
Packs
Coverage per pack varies by brand and R-value. Takeoff uses typical NZ glasswool figures — check the label and change it if yours differs.
Worked example
A 3-bedroom house: seven rooms including a bathroom and hallway, R3.6 ceiling, R2.6 walls, R2.6 underfloor, and acoustic batts in two internal walls.
| Item | Qty |
|---|---|
| Ceiling | |
| R3.6 ceiling batts≈7.7 m² per pack · 94.4 m² + 5% waste | 13 packs |
| Walls | |
| R2.6 wall batts · 90 mm≈11.3 m² per pack · 83.2 m² + 5% waste | 8 packs |
| Underfloor | |
| R2.6 underfloor batts≈10.6 m² per pack · 94.4 m² + 5% waste | 10 packs |
| Internal walls (acoustic) | |
| Acoustic wall batts · 90 mm frame (e.g. Pink Batts Silencer 100 mm)≈14.4 m² per pack · 19.2 m² + 5% waste | 2 packs |
| Underfloor | |
| Ground moisture barrier250 µm polythene · 4 × 25 m roll · 108.6 m² incl. laps | 2 rolls |
| DPM tape48 mm polythene tape · For laps | 2 rolls |
This is the list Takeoff produced for that job. Your list will change with your sizes and settings.
Check before you buy
- Acoustic walls: count each internal wall once — if two rooms share a wall, enter it in only one of them. Doors in those walls aren’t taken off. For best results pair with GIB Noiseline and seal gaps.
- Underfloor uses each room’s floor area. On a two-storey house, only include the ground-floor rooms.
- Pack coverage is typical for common NZ glasswool batts and allows for framing. Check the label on the brand you buy, and change it under Adjust specs if it differs.
- Keep the required clearance around downlights, flues and electrical fittings, and wear a mask, gloves and long sleeves.
- New builds and alterations must meet the Building Code’s insulation requirements for your climate zone — check with your designer or council.
What the calculator covers
- Ceiling batts from R1.8 to R5.0
- Wall batts for 90 mm and 140 mm framing
- Underfloor batts or polyester
- Acoustic batts for internal walls
- Ground moisture barrier and tape
- Your own pack coverage if it differs
Questions
How many packs of insulation do I need?
Work out the area for ceilings, walls and underfloor separately, then divide each by the coverage on the pack and round up. For the 3-bed house on this page that is 13 packs of ceiling batts, 8 of wall batts and 10 of underfloor.
What R-value do I need?
It depends on your climate zone and whether it is a new build or a retrofit. New builds and alterations must meet the Building Code’s requirements — check with your designer or council.
Do I take off windows and doors?
Yes for walls. Takeoff subtracts them using typical sizes you can change.
Get your own list in under a minute
Put in your sizes. Print it, save it as a PDF, email it or take it to your supplier.
Start your insulation list